Pool Breeze Stain Remover Dry

Add 2.5 pounds for every 20,000 gallons of pool water.

1. Brush affected areas.
2. Adjust pool pH between 6.8 and 7.2 and allow chlorine or bromine level to drop to less than 2 ppm.
3. Add 2.5 pounds for every 20,000 gallons of pool water directly into the pool.
4. Apply Stain Remover Dry along the pool walls and especially in the areas where stains are most prevalent.
5. Allow circulation system to run continuously for 24 hours.
6. To prevent stains from redepositing on pool surfaces, use Metal Removing Agent with Stain Remover Dry treatment. Metal Removing Agent is a sequestering agent and will tie up the metal stains once they have been removed and keep them from re-staining the pool.
7. After 24 hours, adjust the pH levels into the proper range of 7.4 to 7.6 and ensure the total alkalinity is in the 80 to 120 ppm range. Maintain normal sanitizer levels.
8. Do not apply shock treatments for at least 72 hours.

Note: Most stains are easier to remove when they are fresh. Old stains or those deeply set may require a second treatment. Applying this product directly to the affected area may be needed for stubborn stains. Not all swimming pool stains are metallic in nature. Stains from oils, vinyl liner fungus, leaves algae and other organic matter may not be significantly affected by this product. See your Pool Breeze retailer for recommendations on treating these types of stains. It is recommended that this product be followed by the Metal Removing Agent in order to keep metals suspended in the water.