Preventative Dosage Rates: Use one Frog Leap All-Out for pools up to 15,000 gallons of water every 3 months. Use two Frog Leap All-Out for pools between 15,000 and 30,000 gallons of water every 3 months.
Treatment Dosage Rates: Use two Frog Leap All-Out for pools up to 15,000 gallons. Use four Frog Leap All-Out for pools between 15,000 and 30,000 gallons of water.
Placement: Turn circulation pump off, turn dial to lowest setting and remove cap from Frog Leap System. If Frog Leap Torpedo Pac is currently being used inside the Frog Leap Anti-Bac Mineral Pac, remove and set aside. Remove cap from Frog Leap All-Out without removing the seal and insert container upside down into the center of the Frog Leap Anti-Bac Mineral Pac pushing down firmly to puncture the seal. Replace the cap on the Frog Leap System. Turn control dial on the Frog Leap System to Maximum, Setting 10 or ON depending on the model and turn pump on for 90 minutes allowing Frog Leap All-Out to circulate through the pool.
Removal: Turn pump off, turn dial to the lowest setting and Remove Frog Leap System cap. Lift the Frog Leap All-Out container up and allow any water in the container to drain through the Frog Leap System before discarding. Note: After discarding Frog Leap All-Out, if water shows more than a hint of blue inside Frog Leap System, replace the Frog Leap System cap, turn dial to maximum, setting 10 or ON and run pump for one minute. Repeat Placement and Removal Instructions if additional Frog Leap ALl-Out is required. Then insert Frog Leap Torpedo Pac following the directions on its label.
